Living in the life, water is an indispensable part of. Use a lot of water, cooking, washing and watering the flowers, etc., as control terminal of pipes, the automatic thermostatic valve in household use frequency is very high, even if it is a good quality automatic thermostatic valve, the years of use would lightly appeared some problems. Automatic thermostatic valve small problem don't want to please professional maintenance man to repair, so that we need to know the automatic thermostatic valve maintenance knowledge.

Automatic thermostatic valve repair, have to know the common trouble and repair methods of the thermostatic valve automatically.

One is the automatic thermostatic valve water split ends. To have automatic thermostatic valve at the top of the part, and then clean screen pack or the whole top part. 2 it is to have noise, to reduce the water pressure of automatic thermostatic valve, emergency shut down automatic thermostatic valve, avoid to remove scale in pipe and so on, check the automatic thermostatic valve and pipe, water pipe and water pipe connection between the are in good condition. Three is the joint between automatic thermostatic valve and pipe leakage phenomenon, to replace rubber ring, careful not to let the breakage of the rubber ring during installation.

When the automatic thermostatic valve thoroughly broken, need to replace the automatic thermostatic valve. First of all, thoroughly wash dirt such as sediment of pressure pipe and so on. When installation should take two inlet pipe of each on the two Angle valve and automatic thermostatic valve, doing so increases the insurance after control and convenient maintenance. Must know hot to the cold water installation method of automatic thermostatic valve, the general is on the left side, the hot water is on the right side with cooling water. Be sure to select the right tools. When installation, to control the pressure, do not use too small, so will not be strong, don't be too hard, this might let internal components to fail.